DPM KP (-F)
The DPM KP module is equipped with an integrated microcontroller used to control and dimm 110/230VAC lighting sources, using 4 power outputs: each channel handles up to 2,5A loads (5A in on/off mode). The module is rated to work with 110/230VAC incandescent and halogen lights, or low tension lamps powered by a standard or electronic transformer.
Smart Marine Dimmer Module 110/230 VAC
- 4 dimmer outputs with memory 110/230VAC
- Programmable scenarios via buttons
- 8 dry contact inputs
- Electronic protection against overload and short circuit
- Monitoring LEDs and control buttons on the front panel
- DIN rail installation (9M)
- Detachable terminal blocks
- Formal coating treatment
The module has 8 inputs that can be connected to any kind of dry contact, pushbuttons and sensors. The inputs can be used to control each line individually and to activate the pre-programmed scenarios: all on, all off, all 60%, all 20%. The scenarios can be changed and saved using the recall buttons. The setting of on board dispwtiches allows to link up to 4 outputs, to reach a maximum load of 10A.
Feedback (DPM KP-F )
The DPM KP-F module has 4 optoisolated outputs, which are used to keep track of the logical state (on/off) of the dimmable power outputs. The optoisolated outputs can be wired to both positive and negative switching digital input modules to suit any installation requirements.
|Electronic power supply||20-28VDC|
|Maximum electronic requirements||2W (85mA @24VDC)|
|Power supply for dimmer outputs||110/230VAC|
|Output power supply||2,5A each|
|Feedback outputs (DPM KPN-F)||Max. voltage 48VDC/24VAC, 12mA|
|Dimensions (W x H x D)||159x58x90mm (9 M)|