MAXI DOLPHIN DALI

Marine Direct Current Dimmable Electronic Drivers Multivoltage-Multicurrent for Power LED and LED modules

  • IP20 independent driver, for indoor use.
  • Multi-power driver supplied with dip switch for the selection of the output current.
  • Active Power Factor Corrector.
  • Light regulation 0-100% by means of PUSH function or Interface 1...10 V (1...10VDC source with double or reinforced insulation with respect to AC mains).
  • Light regulation 0-100% by means of PUSH function (mains voltage):
    - a short push to turn on and off;
    - a longer push to increase or decrease light intensity;
    - regulation automatically stops at minimum and maximum values;
    - for another on, regulation or off command, release the push button and give the desired command again.
  • Maximum length of the cable, from push button to last driver, must be max. 15m. In case of applications where the cable is longer than 15m, keep this separate from the 110-240V mains cable.
  • Possibility to use PUSH function to 4/5 drivers without sync cable.
  • Synchronization cable supplied separately.
  • Max. 10 drivers synchronization, is possible command only one driver (1 Master + 9 Slaves).
  • ATTENTION: only use normally open push buttons with no incorporated warning light.
  • Features DALI dimming:
    - Memory function for sets or light groups;
    - Recall of stored functions;
    - Compatible with standard DALI interfaces.
  • Class II protection against electric shock following direct or indirect contact.
  • Current regulation ±5% including temperature variations.
  • Input and output terminal blocks on the same side (terminal area 2,5mm2).
  • Clamping screws on primary and secondary circuits for cables with diameter: min. 3mm - max. 8mm.
  • Driver can be secured with slot for screws.
  • Protections:
    - Against overheating and short circuits;
    - Against mains voltage spikes;
    - Against overloads.
  • Thermal protection = C.5.a.
  • Can be switched on and off on secondary circuit for power LED.
  • Auxiliary output 12V max. 50mA.
  • Analogical input for thermal sensor connection.

Reference Norms EN 50172 (VDE 0108); EN 55015; EN 60598-2-22;
EN 61000-3-2; EN 61347-1; EN 61347-2-13; EN 61547;
EN 62384; EN 62386-102; EN 62386-207; VDE 0710-T14
Voltage 110 ÷ 240 V ; ENEC at 220 ÷ 240 V
AC Operation range 99 ÷ 264 V
DC Operation range 170 ÷ 280 V (No PUSH mode function)
Frequency 50 - 60 Hz
Power 0 ÷ 50 W
Lamps Power LED

Download