DMX-PWM INTERFACE

DMX – PWM signal converter

• Interface which can convert a signal with DMX protocol into three separated PWM signal.
• DMX address selection through 3 selectors on the upper side of the interface.
• Through 3 PWM outputs it is possible to connect up to 30 drivers of the DOLPHIN series through the sync cable, one for each RGB channel (supplied separated).
• The converter can be powered directly from the mains (100 ÷ 240V_AC).
• Opto-isolated “Open collector” PWM output.
• Features of the DMX regulation:
  – Stand-alone mode with 16 light show and 5 cycle speeds set by dip switch. Possibility to use a push connected to the primary side to stop and start cycle and switch on and off;
  – DMX mode based on DMX 512 Standard. Dip switch for setting DMX address and line termination resistor;
  – LED indicator of the state of DMX transmission and show speed;
  – Quarz for 12 hour syncronized show without DMX connection.
• Protections:
  – against input overvoltages from mains;
  – against short circuit and open circuit;
  – thermal and overload.